Buddy

PSA 10 Centering Requirements: Ratios by Grade Explained

PSA 10 centering requirements for front and back, with a ratio table by grade, a worked 55/45 example and how to measure your own card before grading.

Updated 9 min read

Grade from card grading feature in Buddy
On this page
  1. What the PSA 10 centering ratio means
  2. Can 60/40 centering still get a PSA 10?
  3. Can you get a PSA 10 with 55/45 centering?
  4. What is the 55/45 rule?
  5. How to measure your card against the PSA 10 limit
  6. Why centering decides so many PSA 10 outcomes
  7. Frequently asked questions
  8. Sources

PSA requires 55/45 or better centering on the front of a card for a PSA 10 Gem Mint, and 75/25 or better on the back1. That applies to both axes, left/right and top/bottom, and the worse axis decides the result. A card at 60/40 on the front caps at PSA 9.

The table below puts the numbers in one place before the detail. Figures come from third-party pages that collect PSA's published tolerances, read in November 2026.

PSA gradeFront centering (max)Back centering (max)
10 (Gem Mint)55/4575/25
9 (Mint)60/4090/10
8 (NM-Mint)65/3590/10
7 (Near Mint)70/3090/10
6 (EX-Mint)80/2090/10
5-485/1590/10
3-190/1090/10

Source for the table: Rectifi's centering requirements page, last updated July 20261.

What the PSA 10 centering ratio means

A PSA 10 allows the printed area to sit off-center by up to 55/45 on the front and 75/25 on the back1. The ratio is written as the larger border over the smaller one. So 55/45 means one border takes 55% of the total margin on that axis and the opposite border takes 45%.

Each axis is measured on its own. A card that is 50/50 left to right but 58/42 top to bottom is a 58/42 card, and it misses the PSA 10 front threshold1. Another source describes the same logic: the worse of the two ratios typically determines the centering impact on the grade2.

Centering is also the most objective of the four things PSA looks at. Corners, edges and surface involve judgment. Centering is arithmetic. That is why you can check it at home before you pay for grading.

Some older guides quote 60/40 as acceptable for a PSA 10 front. Some pages and older documents quote 60/40 as acceptable for a PSA 10 front. The CardGrader guide notes that PSA's current published standard says 55/45, and that in the author's experience results can vary by grader3. Treat 55/45 as the line and 60/40 as a miss.

Can 60/40 centering still get a PSA 10?

No. A card at 60/40 on the front is a PSA 9 on centering alone, because the PSA 10 front limit is 55/452. PreGradeCards puts it plainly: 60/40 looks centered to the naked eye, but it gets a 9, not a 10.

The Rectifi table lists 60/40 as the PSA 9 front tolerance1. Its FAQ gives the same answer: a card at 60/40 on the front caps at PSA 9.

The gap between the two ratios is small. On a card with 6 mm of total border on an axis, PreGradeCards shows the split like this2:

Left borderRight borderRatioFront centering outcome
3.0 mm3.0 mm50/50Within PSA 10
3.3 mm2.7 mm55/45Within PSA 10 (at the limit)
3.6 mm2.4 mm60/40PSA 9
3.9 mm2.1 mm65/35PSA 8
4.2 mm1.8 mm70/30PSA 7

A 0.3 mm shift in one border moves a card from 55/45 to 60/40. You will not see that by eye. Both the PreGradeCards and Midpoint write-ups warn against eyeballing for this reason24.

Where 60/40 can still work

A 60/40 front is not a bad card. It still fits a PSA 9. Other graders are more forgiving at the top: ACE allows 60/40 on both sides for an ACE 10, and Beckett's published BGS 9.5 front tolerance is 55/45 per Rectifi, with PreGradeCards reporting a looser 60/40 for the same grade12. Check Beckett's own published standard before you choose a company on that basis. The comparison of Beckett and PSA grading covers that decision in more depth.

Can you get a PSA 10 with 55/45 centering?

Yes, as far as centering goes. A card at exactly 55/45 on the front sits at the PSA 10 limit, and the Midpoint guide states that PSA 10 front centering can be as wide as 55% on one border and 45% on the other4.

But centering is only one of four requirements. CardGrader's guide states that PSA grades on centering, corners, edges and surface, and that you need to pass all four for a 103. A card at 55/45 with one soft corner is still a 9.

CardGrader also gives a worked example. A left border of 2.2 mm and a right border of 1.8 mm is 55/45, right at the limit. A left border of 2.4 mm and a right border of 1.6 mm is 60/403. The author advises aiming for 55/45 or better, and calls a card sitting at 60/40 "basically flipping a coin." Read that as one hobbyist's experience, not a PSA rule.

Treat a card measured at exactly 55/45 as risky. Your measurement has error. A photo taken at a slight angle changes the apparent border widths and can push a result across a threshold1. If your measurement lands at 54/46 or better on both axes, you have some margin. At 55/45 you have none.

What is the 55/45 rule?

The 55/45 rule is the front-centering limit for a PSA 10 Gem Mint: the larger border may take no more than 55% of the total border width on an axis3. The rule is not unique to PSA. Rectifi's comparison shows that 55/45 is the gem mint bar at PSA, BGS 9.5, CGC 10, SGC 10 and TAG 101.

Where the companies differ is the back, the Pristine tiers and how fast grades fall off below the top. Rectifi's top-grade comparison shows the spread:

ServiceTop gradeFront (max)Back (max)
PSA10 (Gem Mint)55/4575/25
BGS10 (Pristine)50/5055/45
BGS9.5 (Gem Mint)55/4560/40
CGCPristine 1050/5050/50
CGC10 (Gem Mint)55/4575/25
SGC10 (Gem Mint)55/4555/45
TAG10 (Gem Mint)55/4565/35
ACE10 (Gem Mint)60/4060/40

Source: Rectifi, last updated July 20261.

Two details matter for PSA specifically. PSA does not award half grades, so a card that narrowly misses a 10 becomes a 93. And PSA's back tolerance is loose. A 75/25 back is allowed for a 10, so back centering rarely sinks a card. Front centering is where most misses happen.

How to measure your card against the PSA 10 limit

Measure the border on each side of one axis, add the two numbers, and divide each side by the total. That gives you the ratio for that axis. Repeat for the other axis.

The Midpoint guide describes the steps4:

  1. Measure the distance from the card edge to the edge of the printed image on both sides of one axis.
  2. Add the two measurements to get the total border width for that axis.
  3. Divide each side by the total and multiply by 100.
  4. Repeat for the other axis and use the worse result.

Their worked examples: a left border of 2.5 mm and a right border of 2.0 mm gives 56/44, which just misses the 55/45 limit. A top border of 3.0 mm and a bottom border of 2.5 mm gives 54.5/45.5, which just passes4.

Tools and what they cost

PreGradeCards lists a metric ruler at about $2 and a digital caliper at about $15 for high-accuracy measurement, with a dedicated centering tool at about $20 and phone apps free but medium accuracy2. These are that site's figures, read in November 2026. Rulers and calipers are awkward on a card you care about. Rectifi points out that a photo must be flat, or corrected for perspective, before measuring1. For a closer look at measuring tools, see the card centering calculator guide.

Check centering and the rest in Buddy

Centering is one of several things standing between your card and a 10, so a ratio alone does not tell you whether to submit. Buddy is an AI Pokémon card grader for iPhone. Take photos of your card in Buddy and it measures centering against grader standards for a potential 10, then estimates the odds of each grade from PSA, CGC, Beckett, TAG and SGC.

Buddy also checks the card for authenticity, looking at lettering, numbers, print and foil against real cards, and shows pricing based on real sales from platforms like eBay and TCGplayer. You see the likely grade and the card's value before you pay a grading fee.

Why centering decides so many PSA 10 outcomes

Centering is the top reason cards miss a 10 and the easiest to check at home, according to the CardGrader guide3. The price gap between a 10 and a 9 is why it matters. CardGrader reports that PSA 10 cards sell for 2-5x more than the same card at PSA 9, and the multiple can reach 10x or higher for high-end vintage.

Card-level examples from PreGradeCards show the same cliff for modern rookies. It lists a Zion Prizm RC at $1,200 in a PSA 10 (55/45) versus $350 in a PSA 9 (60/40)2. Those are sports-card figures from one site, so use them to see how steep the cliff is, not as Pokémon prices.

Centering is also where checking first pays off. Corners, edges and surface need a loupe and good light. A centering measurement needs a ruler or a flat photo. If a card fails the 55/45 test on either axis, you know before submitting that a PSA 10 is off the table, and you can decide whether a PSA 9 is still worth the fee. For the fee side of that call, the PSA grading cost guide lays out prices by company.

Frequently asked questions

What centering do you need for a PSA 10?

PSA requires 55/45 or better on the front and 75/25 or better on the back for a Gem Mint 101. Both the left/right and top/bottom axes must meet the front limit. The worse axis decides.

Can 60/40 centering still get PSA 10?

No. A 60/40 front is the PSA 9 tolerance, so the card caps at a 9 on centering alone2. Some older or informal sources quote 60/40 for a 10, but PSA's current published standard is 55/453.

Can you get a PSA 10 with 55/45 centering?

Yes, for the centering requirement. 55/45 is the limit for a PSA 10 front4. The card still needs sharp corners, clean edges and a clean surface, because PSA grades all four and one weak area lowers the grade3.

What is the 55/45 rule?

It is the maximum off-center ratio allowed for a Gem Mint front: one border can take up to 55% of the total margin on an axis and the opposite border at least 45%3. Most major graders use it as their gem mint bar1.

Can I get a PSA 10 with bad centering?

Not if the front is worse than 55/45 or the back is worse than 75/251. PSA does not award half grades, so a card that misses on centering drops to the next whole grade3. If your centering is poor, a company with a looser top tolerance, such as ACE at 60/40, may fit better.

Is back centering as strict as front centering at PSA?

No. PSA allows 75/25 on the back for a 10, against 55/45 on the front1. PreGradeCards makes the same point: a 60/40 back is acceptable for a PSA 10 if the front is 55/452.

Sources

  1. 1Card Centering Requirements: PSA, BGS, CGC, SGC, TAG & ACEgetrectifi.com
  2. 2Card Centering Standards 2026: 55/45 vs 60/40 PSA & B…pregradecards.com
  3. 3What Is a PSA 10? The Standard, the Odds, and What Grading Now Costscardgrader.ai
  4. 455/45 Centering Explained: PSA 10 Tolerance & Exampleblog.cardcenteringtool.com

Buddy is independent and isn’t affiliated with PSA, CGC, Beckett, TAG, SGC or The Pokémon Company. Fees and prices change; check the sources for the latest.

Check your next card before you send it off.

Buddy grades from two photos by the rules of PSA, CGC, Beckett, TAG and SGC, checks for fakes, and shows what it sells for.

Your phone
Download on the App Store

Free to download, with 3 free scans.

More articles